Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My edc
#1

My last knife was a kizer activ bantam and I really liked it.  Unfortunately I broke my never use a knife as a pry bar rule and snapped the tip off.  I intended to reshape it but then I used it to get rid of some unused wire in my freightliner.  There's another rule, only cut one wire at a time.  Bzzap!  Now it also has a pretty good divot burnt into the blade. 
I attempted to buy another one and it was discontinued.  I ended up with a zero tolerance knife with a 4" blade.  It's a touch large for a pocket knife but I'm getting used to it.
After looking at bladehq's steel characteristics page I gave s35vn a try with the kizer and decided I like that steel, so my zero tolerance is made with the same steel.  I don't like tiny knives as I find them difficult to use with my big hands, so 3-4" is about right for me.
Hopefully, I'll not have a brain fart and abuse this one so it'll outlast me and my grandchildren.  Unless you work in a packing house it's nearly impossible to wear a knife out.
[-] The following 1 user Likes tommag's post:
  
Reply



Messages In This Thread
My edc - by tommag - 07-06-2024, 12:13 PM
RE: My edc - by specops56 - 07-08-2024, 05:20 PM
RE: My edc - by srjdsmith - 07-08-2024, 08:44 PM
RE: My edc - by RocketFoot - 07-09-2024, 08:57 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)